Mock TrueRC Singularity FPV Antenna
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A quick way to visualize antenna mounting on your quad.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I wanted a way to visualize and test antenna mounting without paying for the $20 antenna and realizing I mucked up my measurements.
Designed to fit a piece of 1.75mm filament to roughly match the coax wire for positioning sake. I liked a short section of TPU for this purpose.
Channel for the filament is 7.5mm deep. Then, just cut to your desired length. Remember that the length is measured from the bottom the antenna's main body, not the taper to the wire. See picture five for more details.
Link to antenna in question
PLEASE NOTE: This is accurate to the best of my abilities. It can only approximate the dimensions of the actual antenna and it's weight, though it should be relatively close.