1 / 10
AirGradient DYI Modular Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
I soldered ESP right on the board but made display detachable. This way I got display sitting 6mm lower then top of PM senser. If you did the same, this case might look better for your setup.
Locate all items surface down so you don't need any supports.
TOP slides into BASE on rails. Sung fit. Can slide out if needed with a bit of patience. BOTTOM works the same as in original model and reuses same clips. Insert one side right away then snap the other side.
Tested on a few PCB v3.0. Should fit 4.0 and 2.x used in original work since no size difference between them.