Brompton saddle mount rear bike light holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rear bike light holder for Bromptons. Mounts to the exsting saddle hole with a 12mm M5 bolt. Parametric file included.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 27
- Makes
- 0
- Views
- 376
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Share Alike
A mounting point for bike lights that normally mount to tubes that attaches to the saddle of a Brompton. Requires a 12mm M5 bolt to attach but uses an existing hole in the saddle so no modifications required. Doesn't impede folding. Check your saddle has this hole before printing.
Designed to fit the the light shown in the picture (cheaply avilable from Aliexpress, supports USB C-C charging) but should accpet most small bike lights. I've also included parametric FreeCAD file if you want to try and adapt it to fit a different design.
I printed in 95A TPU with 10% for robustness but other filaments should work fine. I accidentally used a 0.1mm high detail layer height but coarser should work fine. No supports should be needed with the default files as the overhangs are all sloped. I've split the main holder and washer into separate parts for ease of printing, washer sits betweeen the holder and saddle to give clearance over a lip. Thread the bolt through the two parts then bolt it into the saddle.
Do check out the remixes of this model, KXA has been kind enough to design an improved spacer to stop the mount rotating (I've not tested it myself).
If you decide to adjust the FreeCAD file I offer the following notes and suggestions:
-Select the "Parameters" object from the list of objects and adjust the values within to modify the design.
-Parameter names are all mostly self explanatory. “Top” and “bottom” refer to the print orientation. The print gets mounted upside down so “bottom” ends up against the saddle and “Top” is closest to the ground.
-If you adjust the diameter of the top section adjust the height of the taper to ensure you don't create an overhang needing supports.
-Spacer washer parameters are unused. It ended up being easier to set the top and bottom heights and tapers to 0.001mm and adjust the main heihgt and diamteer to produce a washer without extra design work. You can most likely re-use the same washer and jsut generate a new holder.
-You may want to add a chamfer to eddges at the bottom of the design to compenstae for elephant foot-ing. I had to clean up my print with a scalpel to compensate for this.
I release this design under a CC BY-SA 4.0 license. Have fun! https://creativecommons.org/licenses/by-sa/4.0/