Modern Cabinet With Drawers | Print Your Furniture
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small 3D printable cabinet with a wooden top panel and two drawers!
- Rating
- 0 / 5
- Likes
- 634
- Downloads
- 534
- Makes
- 0
- Views
- 14,469
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to have a small side table next to my sofa on which I could put things. Instead of just screwing four legs under the wooden top, I designed a small cabinet with two drawers that is fully 3D printable.
You will need a nice wooden board, as well as some heat inserts, screws, threaded rods and pull-outs for the two drawers.
A detailed material list can be found below.
The cabinet is 530mm high, 270mm wide and 490mm deep.
This project was also my debut in the world of YouTube videos! You can see the construction and much more details about the project than I can write down here in the following video, have fun!
Important Info about the knobs:
I've uploaded the knobs in different versions. In the folder “Mold For Epoxy Resin” you will find the knobs including the mold I used to cast the epoxy resin knobs, you can do exactly as I did in the video.
I have also uploaded the same knobs with a hole for a heat insert, which you can then use as a simple FDM print.
The version I got from Justway in titanium has also been uploaded, you can of course have them print it for you or try it yourself with your FDM printer. In both cases, an M4 thread has to be cut into it. A corresponding hole is already there.
Sponsored:
Formfutura provided me with their Galaxy Space Grey PLA for the print, which you can find in the Formfutura store here: https://formfutura.com/product/galaxy-pla/
Even though I used PLA for the print, I recommend that you use PETG, as material creep could cause screw connections to loosen over time in PLA.
Justway sent me two handles printed from titanium for this cabinet. Click here to go to Justway: https://www.justway.com/
I didn't receive any money for it, just the material.
Materials required:
approx. 4kg filament primary color (carcass, PETG recommended)
approx. 1.3kg filament secondary color (drawers, PETG recommended)
some flex filament for the rubber pads underneath
some nice filament for the two knobs
wooden plate 472x270mm
88x M4x8,1 Heat Insert
36x M4x8 Button Head
32x M4x12 Cylinder Head
2x M4x20 Cylinder Head
2x M4x25 Cylinder Head
8x M4x min. 25 (up to 50mm) Cylinder Head
8x M4x413mm threaded rod
8x M4 Locknut
8x M4 Washer
4x 3.5mm wood screw (length depends on thickness of the wooden plate)
Two sets of 400mm full-extension runners (with self-closing mechanism, optionally with soft-closing mechanism, consider using one set with self-closing mechanism and one set without. Two self-closing runners per drawer require more force to pull out the drawer)
Optional: Approx. 2kg gravel for additional weight (grain size 3-5mm, not absolutely necessary, as the cabinet was not as light as expected)
Please leave a like if you enjoy my design. Also feel free to check out my other uploads. :) |