1 / 5
Z Threaded Rod holder and cover for P1P P1S X1C — image 1
1 / 5

Z Threaded Rod holder and cover for P1P P1S X1C

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

fix problem for Z threaded rod of P1P P1S X1C

Rating
5 / 5
Likes
12
Downloads
61
Makes
0
Views
492
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

After a long time of use, my P1 printer has some problems, the print quality is not as good as before even though it is regularly maintained. Recently, I discovered that the gasket between the Z bar and the bearing has been damaged and fallen off. This makes the hot bed unstable, after a while it has caused the hot bed fixing screw to loosen, fortunately the bearing has not broken. I searched for a replacement rubber gasket but could not find one, so I designed this product to replace it.

Note that with P1P P1S X1C printers, after a long time of use, this part may be damaged and degraded, if not replaced in time, it may lead to reduced print quality or damaged bearings.

You can use a wrench to remove the damaged rubber ring. Use grease to lubricate the inside and outside and then install it to fix the Z-axis threaded rod, this part is also the bearing cover.

I print the product with ABS material, but it can also be used well with TPU or PLA.

Thank you very much and all comments are welcome!

Tags