ESP32 - NodeMCU - Case

This is a case for the NodeMCU – ESP32.

⚠ Important Compatibility Notes:

• it fits if the NodeMCU board has mounting holes at each corner of the board (such as the AZ-Delivery ESP32 Dev KitC V2, ESP32-WROOM-32).
• This case does not fit the ESP32 Dev KitC V4 or other variants without mounting holes on the edges of the board.

I hope you like the model! → Makes and Comments are very much appreciated :)

Features:

• Easy and fast to print
• Some space for cables / parts within case
• The ESP32 can be placed either with reset /flash button up or down. If placed up, there are two holes to press these buttons even with closed cap. 
• There is clearance for the GPIOs on top of the cap. In the Box there is a hole (8mm diameter) where GPIO cables can be passed out from / to the box.
• The cap is "clicked" into place (no glue/screws needed) and can be opened again.
• The USB Port of the ESP32 is always accessible.

Supports: 

Not needed

Layer height:

Any (Example: 0.2 mm)

Infill: 

Any (e.g. 15%)

Filament:

Any (Example: PLA)