1 / 5
DHT22 Enclosure Ambient sensor case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case with magnets for placing somewhere in an enclosure.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 65
- Makes
- 0
- Views
- 314
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I’m using the sensor in my Prusa XL enclosure. It’s controlled via the ESP32 camera. I soldered the wires on the camera side and routed them through the lower ventilation slots of Michael Fanta’s ESP camera case. Inside the sensor housing, a 3-pin JST-SM connector is clipped in, allowing the sensor to be disconnected from the camera if needed.
As far as I can tell, the temperature and humidity readings are unfortunately not passed through to Prusa Connect. I hope this will change in the future.
BOM
- 2x M3x16 screws
- 2x M3 nuts
- 2x 6x3 magnets
- DHT22 (AM2302)
- Dupont 3pin
- JST-SM 3pin
Happy printing!