1 / 3
SAB Chisel Handle for Gunpla
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ergonomic handle for SAB Chisels
- Rating
- 4 / 5
- Likes
- 6
- Downloads
- 61
- Makes
- 1
- Views
- 297
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A SAB chisel handle & holder based on the model by side5, redesigned for FDM printability without supports. Great for ergonomic panel line scribing on Gunpla model kits! Features include:
- Collet-style grip
- Knurled tip
- End cap
- Optional 4mm magnet slot (I personally don't use this, but the option is here if you like the extra secure hold)
- Engraved text
Print Instructions
Shaft (plate 1)
- Orientation: Standing up on the base.
- Layer height: The threads need to be printed at 0.1mm. In the included print profile, the shaft is printed at 0.2mm with a layer height modifier at 80mm-88mm to print at the higher 0.1mm resolution.
- Supports: None. Brim optional if you're worried about adhesion, since this is a tall and skinny model.
- Text is added in the slicer. You can adjust the text in Bambu Studio by double-clicking the text, or by using the other print profile with pre-positioned text for all SAB chisel sizes.
Collar (plate 2)
- Orientation: Standing up on the tip.
- Layer height: The whole thing should be printed at 0.1mm for the inner threads and the knurling.
- Supports: None. Brim optional if you're worried about adhesion, since this is a tall and skinny model.
- If you are having issues with clearance, then adjust the X-Y hole compensation. If the model is too tight, increase the hole compensation. If the model is too loose, decrease the hole compensation. You'll need to adjust the X-Y contour compensation by the opposite amount, since the walls on this model are quite thin and won't slice properly if the hole compensation is too big.
Peg (plate 3)
- This piece is optional if you want to seal the hole the magnets go into. About 3 magnets 4mm in diameter should fit.
- Orientation: Standing up on the base.
- Layer height: 0.2mm.
- Supports: None. Brim optional if you're worried about adhesion, since this is a tall and skinny model.
Cap (plate 4)
- Orientation: Standing up on the tip.
- Layer height: 0.2mm.
- Supports: None. Brim optional if you're worried about adhesion, since this is a tall and skinny model.