ESun Empty Spool Lazy Suzan Turntable
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Turn your old ESun spool into a useful turntable
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 328
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Turn your old ESun plastic spool into a turntable/lazy suzan mechanism.
It has 5 parts, a top cover to close the hole, a bottom adapter for a bearing, a base that uses 3 623zz bearings for support, a rim that goes around the spool that should just clip easily similar to all the AMS printed cardboard spool adapters, and little wheels that go around the 608zzbearings.
Printing instructions:
3 walls, 0.2 layer height with 15% Gyroid infil for maximum strength.
Turn on presice wall and height.
Disable only one wall on top surfaces.
Wall order, inner/outer/inner.
For the wheels I printed them in vase mode to remove the seams and reduce friction, and disabled bottom layers, however, it created artifacts on the bottom and needed to be snipped off. I also set wall width to 0.6mm
For the base I suggest putting a height range modifier that starts on 6mm to the end, and giving it 4 wall loops for maximum strength of the bearing holders.
Extra hardware needed:
- One 608zzbearing
- Three 623zz bearings
- Three 12mm M3 Screws
- Three M3 nuts.
Extra suggestions:
Couple it with these drawers
https://www.printables.com/model/1391959-esun-pla-spool-drawers-with-handlesvase-mode