Taig Micro Mill T-Blocks M3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
T-Blocks for mounting accessories to Taig Micro Mills (2018, 2019, 5018, 5019) using M3 Hardware.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 63
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- GNU General Public License v2.0
T Blocks can be a useful addition to any Milling setup. They offer strength and orientation control.
This design was created for Taig Tool's 2019 Micro Mill. Featuring three embedded M3 nuts, this T Block allows for small nonstructural accessories to be mounted to the machine's table: Air Blowoffs, Cameras, Dial Indicators, Limit Switches, Indexing Features, Shrouds, etc.
Best practice is to use a soldering iron to embed the M3 Hardware - while plastic is still setting, tighten bolts to ensure flush alignment. Additionally, hardware can be embedded with pressure using either an M3 Bolt and Nut, or using a vice.
Optimizing for speed with 0.3mm Layers, no supports and adapted settings: a single unit takes 15 minutes to print. A pack of 20 can be completed in under 4 hours.
Tolerances are set to provide a snug fit against Machine's Table, for looser fit, scale down before printing or post process with Sand Paper / File.
Verification Prints performed in Generic PETG.