1 / 2
Parallel Jaw Pliers (even sturdier)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Redesigned parallel jaw pliers to further increase stiffness and strength
- Rating
- 5 / 5
- Likes
- 34
- Downloads
- 110
- Makes
- 1
- Views
- 562
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hardware needed:
- (2x) M3x8 countersunk screws
- (3x) M3x12 countersunk screws
- CA glue (super glue)
Printing:
This model is designed for 0.2mm layer height.
I used 4 perimeters and 100% infill with ColorFabb XT-CF20 and a 0.4mm nozzle.
Assembly:
Note: Both smaller handle halves and both jaws are identical/interchangeable
- Glue the two halves of each handle together with CA glue. Test fit the halves together before gluing to make sure everything fits correctly.
- Position components as pictured.
- Fasten the front pivots with M3x8 countersunk screws.
- Fasten the sliding rear pivots and the center pivot with M3x12 countersunk screws.
- Adjust screws as needed to minimize play while still allowing easy operation.