Raspberry pi klipper KlipperScreen Stand/case for waveshare 7" HDMI LCD capacitive/resistive touchscreen Display B
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stand for a Waveshare 7"HDMI display B or equivalent
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 56
- Makes
- 0
- Views
- 621
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I used the M2.5 8mm standoffs and 4mm M2.5 screws that shipped with the display on the base, and 16mm M2.5 screws to mount the frame, display and spacers onto the base.
The holes on the frame have sacrificial bridging so you will need to use a sharp object to poke them out. I recommend poking them out from the side with the counter bore so it doesn't interfere with the screws. The screws fit pretty tight into the frame so you may need to push them in with a flat surface.
16mm M2.5 screws were just what I had on hand so if you have different screws, you just need different sized spacers. this model only works down to 12mm screws before you start to have issues with fitting the HDMI cable in.
The spacers you use should be your screw length -10
e.g.
16mm screws: 6mm spacers
15mm screws: 5mm spacers
14mm screws: 4mm spacers
13mm screws: 3mm spacers
12mm screws: 2mm spacers
Remixing and feedback are encouraged