1 / 3
Risers for Agility Hex Rings (FPV Whoop Gates)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Risers and connectors for using agility hex rings as FPV Whoop gates.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These hexagon shape rings are common on AZ and make great FPV gates for whoops. To raise them off the ground a bit and stay out of ground effect, these risers are in 25mm (1") and 50mm (2") as well as a connector to connect the pointy ends.
Hex rings used measure 49cm (19") outside, across flats. 11mm (7/16") thick.
Be creative, mix and match, but most important, get out there and whoop!
Print in PETG if using outdoors. Print in Draft (0.3mm layers, 10% grid infill, 2 walls). Print connector on “end” to not need any support.