1 / 1
DGS-105 10 inch rack mount brushed cable passthrough
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
10 inch rack mount for DGS-105 with brushed cable passthrough
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 35
- Makes
- 0
- Views
- 459
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
DGS-105 10 inch rack mount brushed cable passthrough
NOTE: There is a small amount of post processing, After print cut along bottom of brush to separate the bristles. this allows for the bristles to move a bit more allowing for easier cable pass-through. As well as adding a bolt or 2 to keep it from sliding out the back when using a lot of force to put in a cable.
Size: 44.5 x 254 x 105.203 mm
Print recommendations:
- 0.2mm Layer height
- 0.4mm nozzle
- PLA or PETG (Was tested with PETG, YMMV with other filaments)
Tested on a Ender 3v3