1 / 20
65W / 100W DIY Powerbank Case 21700 4S3P pack
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DIY Powerbank using 21700 Lithium Ion Cells in 4S3P configuration and 65W/100W Module
- Rating
- 0 / 5
- Likes
- 43
- Downloads
- 293
- Makes
- 0
- Views
- 2,340
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Whats needed to build this ?
- The 100W/65W DIY Power bank Modules typically available on Ali-express / e-bay etc. (Model : MYZL-YD24-2.32)
- 6x M3*4*5 mm Heat Set Inserts (installed on the Base to secure the Lid)
- 6x M3x8mm Flathead screws (secure the Lid to the Base)
- 2x M2x6mm screws (to secure the powerbank module/board)
- 3mm thick plexiglass / acrylic sheet, cut to appx 25mm x 20 mm - see pictures on how to use the backer/display holder to place the plexiglass
- 8mm Rubber feet (optional)
- 1.27mm Female Headers & 1.27mm Male Headers (Link Here) (to place the display at a better location). Soldered the lines using a 28AWG wires. - See pictures.
- Batteries
- This is designed for 21700 cells in a - 4S3P pack configuration
- I used the BAK N21700CG-50 cells - 5000mAh - so total pack capacity is 15,000mAh
- To get accurate read-out on the display, you need to set a resistor (R24) based on the capacity (defaults to 10000mAh) - this is optional if you are OK with slightly inaccurate read-out of battery %age on the display.
Fusion design file included (.f3d) - so that you can customize this as you want! Some of the dimensions are parameterized !