Chamber heater with IR or Wifi (with mobile App) remote for Elegoo Centauri Carbon & other printer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Chamber heater based on mini heater with a thermostat controlled by infrared remote or Wifi with mobile app remote.
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 57
- Makes
- 2
- Views
- 1,175
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
This is a chamber heating solution for the Centauri Carbon (but also for other printers) based on a "mini heater" and a thermostat controlled by infrared remote control or a thermostat controlled by wifi and mobile app.
Equipment to buy
1 Mini Heater (Aliexpress or Amazon) :
8x3 or 6x1 magnets
1 thermostat (3 options on Aliexpress)
For 24V option : 1 XT60BE-M and XT60H-F :
3 options for the heat deflector (choose the right file) :
no deflector
integrated deflector (option shown here)
separated deflector
A) mini heater modifications
Remove the colored sticker to access the screws. Open the mini heater, desolder the button, and solder two AC wires. For the AC 110-240 option, solder two additional AC wires on the mini heater power connector to power the thermostat.

Reassemble everything, passing the wires through the button hole.

B) Thermostat
Print the correct model based on the chosen option:
DC 24V: "Mini heater + deflector + XT60 V1.1" or "Mini heater + XT60 V1.1"
AC 110-240V: "Mini heater + deflector V1.1" or "Mini heater V1.1"
I use ASA with support.

For the DC 24V option, solder two wires to the XT60 connector and screw it in.

Remove the 4 corner screw of mini heater.

Use 4 screws of the same diameter but of 15mm long to wire mini heater:


Connect wires to thermostat (beware of polarity for 24V DC option) and pass the temperature probe through the hole provided for this purpose.


Attach enough magnets to the back

Print the temp sensor magnetic mount and attach 2 6x1 magnet.

C) Centauri carbon integration
Prepare 2 40cm wire like this :

Unplug the printer, lay it on its side, and remove the metal plate from underneath the printer.

Thread the wires through the hole from inside the printer.


Connect the wires to the printer's power supply.
For 24V option : XT60 wires to 24V printer's 24V power supply
110-240V wires to 110-240V printer's 24V power supply

Close the printer and connect the heater. To position the temperature probe, place it at the same height as, or very close to, the temperature probe in the printer chamber. The excess probe cable can be tucked into the heater box.
Configure the thermostat according to your needs.

D) remote holder on the side of the printer

