1 / 6
40v dual battery carrier compatible with Ryobi — image 1
1 / 6

40v dual battery carrier compatible with Ryobi

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I hate dropping these things

Rating
0 / 5
Likes
10
Downloads
36
Makes
0
Views
246
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

Now you can carry two Ryobi 40v batteries without worrying about dropping them

In addition to this center part which the strap goes into, you need to print two of the
"40v battery interface" found here (GCODE) or here (STL)

You will need 17 1/4" of this...
Strapworks Heavyweight Polypropylene Webbing - Heavy Duty Poly 3/4 Strapping

You will need Qty 8 of these...
0.7mm Pitch M4 x 12MM Socket Head Cap Screws

When assembling this, is it frustrating to get the strap into the channel? YES!
Is it possible? YES!
Will you appreciate it being this difficult now, to prevent it from pulling out later? YES!!!
Start from the inner part (where the hole is, line up the strap just past the hole, and slowly work into the channel only a few millimeters deep until you reach the outer slot.  Keep working it in, using needle nose pliers, shift the strap back and fourth to work it in, after only a few millimeters remain out of the channel you can turn the whole part upside down and push it flat against your work surface.  Repeat on the other side, you're a pro now!  Optionally add some hot glue into the hole at the ends of the strap if you're paranoid.

Push battery in fully to lock in place / Press the removal latch on the battery to pull out

Suggested print settings:
 - 0.20mm QUALITY
 - Prusament PETG (pictured using OVERTURE PETG Grass Green)
 - Infill density 20%
 - Infill pattern Adaptive Cubic
 - 3 Perimeters
 - Supports required (very small)

If you need the STLs of these parts, please see:
https://www.printables.com/model/1303958

  

Don't have a 3D printer yet? That's OK, order already printed from…

https://jpelectron.etsy.com

Tags