Anycubic Kobra S1 Chamber Temp / Humidity Sensor Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This print allows you to mount (with the use of 2 M3x12 screws) a standard Thermometer/Thermohygrometer to your printer!
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 30
- Makes
- 1
- Views
- 359
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Suitable for any thermometer with dimensions of 44mmx44mm, this quick print does not require supports, has minimal bridging and all overhangs are <=45 Degree . Most importantly, the mount does not interfere with the hot bed (z axis).
Depending on your primary filament use, I recommend using a higher GT temp filament - however if you do not have a heated chamber or leave the chamber closed for long prints, it is extremely unlikely that the bottom of the chamber will reach 60 deg C; and PLA should be fine.
Other than that, so long as your tolerances are reasonable, you'll have no problem printing this mount.
NOTE: While it may fit, DO NOT mount on the top hinge, the toolhead WILL crash. (ask me how I know)
The LED inside the printer nicely backlights the thermometer, and it is held in place by snug fit on the two bumps on the inside of the baseplate walls of the print.
You will need 2x M3x12mm Screws to mount this to your bottom hinge of the Anycubic Kobra S1, the factory fitted M3 screws will not be long enough.