1 / 5
Mount for AT42QT1010/Generic Arduino Capacitive Touch Sensor — image 1
1 / 5

Mount for AT42QT1010/Generic Arduino Capacitive Touch Sensor

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Press-fit mounting plates with offsets for Adafruit and generic Arduino capacitive sensors

Rating
0 / 5
Likes
6
Downloads
16
Makes
0
Views
63
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Press-fit mounting plates/spacers for capacitive touch sensors. There are versions of the model for the Adafruit AT42QT1010 and (I think) this generic one: 

These can mount to a surface with (about) M3 bolts (or the American equivalent). The sensors should be able to fit tightly onto the mounting posts while being removeable and retaining the same fit for future use. The offset is designed to avoid possible interference with surfaces below. I printed them with PETG; PLA should be fine as long as you don't plan to hit it with a hammer or something. The post mounting extensions (very top parts) are 2.55mm for the Adafruit version, 2.45 for the other one.

Made this over the summer and finally posted it. The model in the pictures taken on a gray background is a prototype of the Adafruit version, but it is cosmetically identical and the only change made was an improvement on the post tolerances.

Tags