Milwaukee Magnetic Pen Light Holder (No glue required)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I love my pen light but I hate it just loosely sitting around. And this uses magnets you probably already own.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 5
- Makes
- 0
- Views
- 68
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This pen light replaced my gigantic Maglight but I hate leaving it next to my bed where it was always falling off.
It uses the same 6 x 2mm magnets that Gridfinity uses so you may already have some ready to go.
Recommendations:
So I have two suggestions for printing. I used a .4mm nozzle and PETG. I tried it with a .2mm and it failed really bad.
It can be printed laying down, with supports in the magnet holes. But you'll have to remove them afterward and YOU WILL want to glue them in.

My recommendation is to actually print it on end with no supports. To do that, hit F on your keyboard and select the end that doesnt have the cutaway.

From here you can send it and print.

The reason this worked for me is the overhang allowed me a gap to press fit the magnets. They don't go in easily, but they are so tight that I didn't need to glue them at all.
Happy printing!