0,75mm Conector 2 Pin - KZ earphones
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2 pin conector for KZ earphones.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I made this model mainly for a Type-C pin.
However, by using a longer paper clip, it should also be possible to make a Type-B pin, but this has not been tested yet.
There are two models included:
one for the plug (where the clip is inserted)
one for the cap, used to close and secure the plug
You need to bend a paper clip into an L-shaped metal pin, insert it into the plug, and then cut off the excess using wire cutters.
After insert the clip, place the cap over the plug to seal it.
For a better finish and strain relief, it is recommended to add a heat-shrink tube over the cable and cap after soldering.
Printing
Material: PETG
Layer height: 0.12 mm
Brim: 10 mm (outer)
Recommended: print one part at a time