Peugeot 205 Chassis / Floor Pan Replacement Plugs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a 3D-printable replacement for the two large chassis plugs located underneath the Peugeot 205
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 26
- Makes
- 1
- Views
- 119
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printable replacement for the two large chassis plugs (floor pan bungs) found underneath the Peugeot 205 (one on the driver’s side, one on the passenger’s side).
The original rubber parts often degrade over time, fall off, or disappear during restoration, leaving your floor pans exposed to water, salt, and debris. This part is designed to seal those gaps perfectly.
🛠 Printing Recommendations
Material: TPU (Flexible) is mandatory. Do not use PLA or PETG, as they are too rigid and won't handle the vibrations or the fitment properly.
Infill: 20-30% (Gyroid or Grid) is sufficient, or 100% for maximum durability.
Walls: At least 3 wall lines for a good seal.
Supports: Minimal supports might be needed depending on your printer's bridging capabilities.
🔧 Installation Instructions
Clean: Thoroughly clean and degrease the area around the hole on the chassis. If there is surface rust, treat it before installation.
Test Fit: Ensure the print sits flush in the hole.
Seal: Apply a generous bead of Sikaflex (Polyurethane sealant/adhesive) around the rim of the 3D printed part.
Install: Press it firmly into place and wipe away any excess sealant for a clean finish.
Dry: Let it cure for 24 hours before driving.