0x2a's Peugeot Wiper Mount
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.63 – €0.77 net (excluding VAT)
For file: Peugeot HeckwischerV2_0.4n_0.2mm_PETG_MK4IS_32m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.70 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 37.8 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Replaces the back wiper's plastic mount and its cover.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A quick and seemingly lasting fix to prevent the back shield wiper of a persumed Peugoet 206 first generation from around 2010 from hanging down due to an cracked or worn out mount. Fully replaces the original mount and its cover, while reusing everything (e.g. the shaft, nut, spring and wipers). Basically a drop-in replacement.
Designed to be press-fittied over the mounting shaft (the thing below the big nut). Tight enough to fixate itself and might requires the part to be slightly pryed open during installation.
Nonetheless, the additional screw and nut combo allows to further increase tension. The screw should be fixated with a selflocking nut as shown in the picture. Was tested on a week long car trip with strong rain showers on the highway and continued to work multiple months afterwards. Lasted longer than the cars engine.
PETG with 0.4mm nozzle at 0.2mm layer height with 30% infill was used due to its UV resistance and availability. Robust filaments with higher temperature resistance like ASA, PA and PC should also work well and additionally survive hotter summers safely.
FreeCAD project files included.
Check local laws before installation.