Glass Holder for Music Stands | Notenständer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Glass holder for attaching to music stands for glasses and Bottles up to 78 mm in diameter.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 52
- Makes
- 1
- Views
- 243
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial
The design features a modular "Clipper" (clamp) system. Depending on the diameter of your music stand pole, you can print the specific clipper size that fits your gear perfectly.
!! IMPORTANT NOTE !! READ BELOW BEFORE PRINT !!
You need to stop the print at 85.8mm (layer 429 at 0.2mm layer height) and insert the M5 nut into the holder.
!! IMPORTANT NOTE !! READ ABOVE BEFORE PRINT !!
Hardware Needed
To assemble the holder, you will need the following hardware:
1x M4 x 12mm screw: Used for the main hinge mechanism.
1x M5 x 30mm screw: Used to tighten the Clipper onto the music stand pole.
1x M5 Nut
Optional: A small piece of 5mm or 5.5mm heat-shrink tubing (or a small O-ring/rubber gasket) to place on the end of the M5 screw. This prevents the screw from falling out when the clamp is fully opened.
Assembly & Printing Tips
Clipper Selection: Measure the diameter of your music stand tube before printing. Choose the Clipper file that matches your diameter for a snug fit.
Material: I recommend using PLA for all parts.