8x8 (W)LED matrix and/or energy price indicator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the case for 8x8 LED Matrix to display price levels of dynamic electricity tariffs - or any other purpose.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Big thanks to both Till-83 and Hatrick3D for creating and sharing their projects. After discovering them, I was immediately sold on the concept. Like them, I was looking for a simple way to visualize the current electricity price level and the upcoming hourly trend.
As a mechanical engineer, I prefer assemblies where every component has a defined and mechanically constrained position. This remix is therefore a full mechanical redesign focused on robustness, serviceability, and dimensional compatibility — without requiring glue or improvised fixes.
(See the section below for a detailed list of differences.)
The ESP recesses are designed with 0,2–0,4 mm clearance, which should be sufficient for most prints. If your ESP module does not fit, check the USB opening first — slight sagging during printing can affect insertion.
Threaded insert holes were modeled using nominal dimensions. Depending on your printer calibration, you may need to increase them by ~0,1 mm for optimal heat-set insertion. I had to do so for my own print due to minor dimensional inaccuracies in small features.
This GitHub fork [link] is tested and works with the exact materials listed below.
List of materials used to complete this build:
SUNLU PLA Matte (any non-conductive filament is suitable)
Ruthex RX-M2x4 threaded bushing (Amazon.nl)
ISO 7380 - M2 x 10 (KINGMicroschroeven)
ISO 7991 - M2 x 6 (KINGMicroschroeven)
AZ-Delivery (Wemos) D1 Mini NodeMcu with ESP8266-12F WLAN Module CH340G (Amazon.nl)
AZ-Delivery (Wemos) ESP32 D1 Mini NodeMCU WiFi microcontroller (Amazon.nl)
0,34 mm² (22AWG) wire
LED matrix wiring
ESP8266:
5V → 5V
GND → GND
Data → D3 (default in code)
ESP32:
5V → VCC
GND → GND
Data → GPIO4 (default in WLED)