1 / 5
Top filament feed management Prusa Core L, no PC4-M10 — image 1
1 / 5

Top filament feed management Prusa Core L, no PC4-M10

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

To allow for top filament feed management on Core One L while minimizing PTFE tube length

Rating
0 / 5
Likes
2
Downloads
7
Makes
0
Views
160
Reviews
0

Updated at source:

Model information

License
Open Community License v1

I used PCE-HG100, PTEG or PLA+ sould be fine.

Print the two latches, two bolt holders and the support of your choice, model A or B.
Latches have to be printed on their larger surface.
Supports everywhere are needed for model A, while only plate supports are needed for model B.
0.4 nozzle, 0.2 layers, 4 perimeters for each object.

The PC4_M10 connectors are replaced with small latches using an M3x15mm screw and an M3 hexagonal bolt for model A or a simple M3x15 screw for model B.

For model B a M3 tap will be needed to create the threads in the support.

List of materials:

  • 4 x M3x15mm screw

  • 4 x M3 hexagonal bolts for model A
    Nylon stop bolts are a good option for the latches

  • 2 x M3 hexagonal bolts for model B

  • 1 x 30cm PTFE tube

Screw the latches on the support, one on the top, one on the bottom, be careful not to overtighten the screw; the latches must be able to move.
Insert the bolts in the bolts holders.
Remove the two nylon rivets on the left side of the plexi side panel.
Insert the two screws in the support and fix them in place with the two bolts from the inside of the box.
Remove the small PTFE tube from the filament sensor and plug the 30 cm one instead, between the filament sensor and the support.
Insert the PTFE tube in the 4 mm hole at the bottom of the support and turn the latch until you hear a clic.
In the same manner, insert the PTFE tube you want between the top and your device.

Tags