Y-Axis Frame Brace (Ender 3/Pro)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.44 – €4.20 net (excluding VAT)
For file: Y_Bracket_Full_without_Cable.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.82 excluding VAT (range midpoint).
- Weight reported by the author
- 44 g
- Print time reported by the author
- 4 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Frame brace for 4040/2040/2020 extrusions
- Rating
- 4.75 / 5
- Likes
- 155
- Downloads
- 628
- Makes
- 3
- Views
- 3,847
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
In the quest for the most rigid Ender 3 Pro in the land, I stumbled across this model: https://www.thingiverse.com/thing:3343666 from mlynch002 and made some changes.
Changes:
- Repaired and remeshed model
- Resized Holes to M5
- Added flat version without cable cutout
- Added Left, Right models
- Added Full bracket for 4040 extrusions (Ender 3 Pro)
- Added Full bracket for 2020 extrusions (Ender 3)
Hardware Needed:
- M5 Bolts 8-12mm (14 for Full Bracket, 7 for Half Bracket)
- M5 T-Nuts (14 for Full Bracket, 7 for Half Bracket)
Print Settings:
- Layer Height: 0.2mm
- Line Width: 0.6mm
- Brim: Recommended (thin walls that make up the side of the Y-Axis support like to peel)
- Infill: your choice, I did 100%
- Wall Count: 3-4
- Support: Yes, for models with cable cutout (otherwise, no)
- Y_Bracket_Full_without_Cable took 4 hours at 60mm/s (44 total grams)
- Filament: 3D Fuel Pro PLA - Midnight Black
Installation Notes:
- See pictures for more details
- After installing the appropriate nuts and bolts, slide bracket onto the Y-Axis extrusion and slide until it is snug against the horizontal extrusion (Might be a tight fit, depending on your printer tolerances)
- All versions of the bracket should fit on the front or rear of the center extrusion
- The models labeled “RIGHT” should fit with the stock electronics case on the Ender 3 family of printers
- I am using dual "FULL" brackets since I moved my electronics and screen to an external enclosure
- .obj file included if you want to make any changes