1 / 3
KlickyKlacky/BoxTurtle Magnetic Door Latches M3 Nut remix — image 1
1 / 3

KlickyKlacky/BoxTurtle Magnetic Door Latches M3 Nut remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

M3 nuts, improved print orientation, other small tweaks.

Rating
0 / 5
Likes
3
Downloads
13
Makes
0
Views
174
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Using the original, I ran into a few issues - 

  • The heatsets are in pull-out orientation, which isn't ideal, especially if using an auto driver.

  • The final magnet flush-ness was extremely sensitive to the heatset placement - if the heatset wasn't perfectly level, then the magnet would be veery noticeably tilted

  • Swapping heatsets to try different sizes was slightly too much work

  • The print orientation was vertical, and this led to occasional cracking when securing to the 2020 with an auto driver

  • The clearance of the little fins was slightly too close, such that even the short end of a roll-in nut would bump a heat set insert.

So the changes:

  • M3 nuts. These will pull in and align themselves, and the insertion slots are hidden when actually mounted. They slide in and out cleanly.

  • Designed to print support-less on the wide side. This improves the compression strength a little in the two relevant dimensions, instead of being extremely strong for the magnets, and useless for the mounting.

  • Alignment fins slightly adjusted to allow an entire M3 roll-in nut to fit.

  • Magnet holes are bumped to 3.2mm in depth, as this is what mine were measuring. 

  • Added some fins on the "back" of the unit, so they tighten snuggly against the 2020 instead of tilting backwards

BOM, Per Unit (You will need 2 units to make a linkage, and probably two linkages per door.For 4 total.)

  • 4 10x3mm Countersunk magnets.

  • 4 M3 nuts

  • 4 M3 FHCS

  • 2 M3x10 SHCS

  • 2 M3 Roll-in / M3 T-nut

Sizing is intended for ABS with no shrink adjustment. It's fine if you do, the hardware will just be a little more tight.

Tags