AIRSOFT PISTOL MAGAZINE FEED LIPS

UPDATE!
6-3-2026
- Added V1.69 - the 69th version

Features/improvements

- GIGGITY!
- Entire feedway asymmetrically offset to the right by 1mm ( see notes for explanation)
- Refined internal feed way 
- Beveled feedway exit
- eliminated unneeded geometry
- 1.69  GIGGITY! Grams  ( without support), 1.94g ( with support)

NOTE- the factory  feedlips are mostly symmetrical to themselves and the magazine, and so were my previous version, i noticed there was a gap on the left side of the feed lips between them and the tube thing, i then noticed that the factory feedlips, despite being symmetrical, did not center its feedway on the barrel, as the barrel seam was not centered, by about 1mm to the right ( eyeballed) about the same as the gap on the left side of the tube. so i offset the entire feed way by about 1mm to the right, now it centers ( close enough) on the center of the barrel, instead of the magazine, which DRAMATICALLY reduced cycling issues.

i do not plan on returning to a symmetrical design, but if enough people need it ( and leave comments about it), i could probably try to make it happen, but i think this asymmetrical version feeds MUCH smother now.

NOTE 2 - deleted old notes, details, and files
________________________________________________________________________________________________________________________________

________________________________________________________________________________________________________________________________

RECCOMENDED -  use the settings described in Makers Muses video for strong prints

________________________________________________________________________________________________________________________________

PAIRS WITH PRINTBALE GASKET