1 / 5
SV08 Toolhead Cover Easy Print
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix focused on improved printability and strength
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 18
- Makes
- 0
- Views
- 144
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print settings:
No supports needed, just remember to remove the in-built supports before using. I used .2mm layer height and 10% hex infill. Prints on its face. Most hi-temp filaments will work, I used ABS.
Inbuilt supports are marked with "SUPP" or "S" and should be removed before use.
BOM
8 x 4Dx3h mm round magnet (or other height, just modify the hole depth to fit)
1 x 24v 5020 fan, same as original. A decent bit of the ~20g weight savings comes from using a lighter fan than stock
TAKE CARE WHEN INSERTING MAGNETS
Walls are deceptively easy to snap with too much force, be gentle!