Lenovo ThinkCentre M720q 10" (vertical) Rack Mount - with two Keystone Sockets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Inspired by the 10" Rack Mount by Tim. Both Keystones on the left. Suited for vertical mounting.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 87
- Makes
- 0
- Views
- 888
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Note: Please print the STL in the "Long Plug+Boot" folder to avoid issues with RJ45 Plugs being too long.
The version you see in the pictures has a flaw i only noticed after taking said pictures: Ethernet cables with a maximum Plug + Boot - Metal part and Strain Relief - length of 40mm should still fit onto the backside of the keystones. Any longer than that and you will run into issues. The version in the "Long Plug+Boot" folder adds ~15mm, which should account for most plugs.If that isnt a problem for your usecase, you can find the model shown in the pictures in the "Short Plug+Boot" folder.
Foreword
I was in the proccess of reorganizing my hardware when i had the idea to fit a small horziontal rack under my desk. I wanted a vertical 10" Rack Mount and really liked Tim's design. So i printed it without realizing that there was no way for keeping the Mini PC secured while mounted in a vertical position.
Thus i designed this 10" Rack Mount for the Lenovo M720q (and probably similar Mini PCs/ThinClients) from scratch, heavily inspired by the features (and measurements) of Tim's original design.
Features / Differences:
Keystones
Both Keystones on the left (closer to the NICs) and rotated by 90°
Removal of Keystones though holes on the front (while PC is installed) and sides
RJ45 Plugs can easily be removed by hand (backside)
Edge above the Mini PC/ThinClient to keep it from falling while mounted vertically
"Rails" instead of “spots” for the feet
I used slightly different print settings:
Material: PETG
Perimeters: 3 Walls
Infill: 15%
Top/Bottom Layers: 3 layers
Supports: none
Orientation: Front face down, reorientation required
Brim: optional, didn't use one
Assembly works just like Tim's version with the exception that the PC slides in from the front.
For compatibiliy with Keystones and other Lenovo Mini PCs / ThinClients please check out Tim's model page.
