1 / 7
Creality Space Pi X4 PTFE Fittings - PC4-M6 — image 1
1 / 7

Creality Space Pi X4 PTFE Fittings - PC4-M6

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fittings to stop your PTFE getting pulled in to your dryer.

Rating
4 / 5
Likes
53
Downloads
363
Makes
0
Views
1,981
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

Printed fittings to use with the Creality Space Pi X4 and PC4-M6 fittings that prevent PTFE tubes sliding in to the standard ports and getting wrapped around your filament spool. Because the PC4-M6 fitting butts up to the printed part, feeding filament out to your PTFE tube is smooth and easy.

Three sizes are included, one for the front ports and two for the rear, the longer one penetrates through the rear port, the shorter one is flush with the back of the unit (shown in the photos).

I printed mine in ABS at a 0.15mm layer height and the M6 threads work well.

Pop out the support with some tweezers and then run a 2mm drill bit through the hole to clean it up.

To remove them, just slide some tweezers between the stock fitting and the printed part and pull it out.

Tags