Washer Bearing Kit 285203 Install Helper / Guide
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Install Helper / Guide for hammering in the bearings and seals in the 285203 kit.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 14
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Install Helper / Guide for hammering in the bearings and seals in the 285203 kit.
It's basically impossible to install the seals in this kit without some sort of guide.
NOTE: Make sure you sand the inside of the tube the bearings/seals sit in with 320+ grit sandpaper or they will never go in.
You can place this over the end of the tube and it will guide the bearings or seals in straight as you hammer them in.
For the bearings, place the bearing in the guide and use a 1 1/8" socket (I used a TEKTON 1/2 Inch Drive x 1-1/8 Inch Shallow 6-Point Socket - SHD22029) to hammer the bearing into the tube. Once it's past the half way point you can remove the guide and use the socket and an impact extension to hammer it in the the correct depth.
For the seals, make sure the seal will go in the correct direction then use the old bearing to hammer in the seal.