Xiaomi Viomi Aeolos 9 Extension Wand Release Button / Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Viomi Aeolos 9 Vacuum Cleaner Tube Latch / Button Replacement Release Button for Viomi Aeolos 9 / Xiaomi Vacuum
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 15
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
Description
A replacement release button (latch) for the Viomi Aeolos 9 (Xiaomi ecosystem) cordless stick vacuum cleaner.
The original injection-molded ABS button frequently breaks at the small side pivot pins due to mechanical stress. This 3D-printed model is a direct drop-in replacement to fix your extension wand or attachments without buying a whole new tube.
Print Settings & Orientation Tips
To prevent the side pins from shearing off along the layer lines, do not print this flat on its bottom.
Orientation: Lay the button on its side (rotate 90°). This ensures the layer lines run along the length of the pivot pins, making them significantly stronger under press load.
Supports: Yes (organic/tree supports recommended for clean removal).
Material: ABS, ASA, or PETG. (Do not use standard PLA, as it is too brittle for this spring-loaded mechanism).
Infill: 40–100% (Grid or Gyroid).
Wall Loops (Perimeters): At least 4 walls for maximum strength around the hinges.
🇷🇺 Russian Description
Описание
Запасная кнопка-фиксатор (защелка) для беспроводного вертикального пылесоса Viomi Aeolos 9 (экосистема Xiaomi).
Заводская кнопка сделана из ABS-пластика и со временем ломается в месте боковых штифтов (усиков) из-за постоянной нагрузки. Эта модель полностью повторяет оригинал и позволяет отремонтировать удлинительную трубку или насадки без необходимости покупки новой детали в сборе.
Рекомендации по печати и ориентации детали
Чтобы боковые усики не отломились по линиям слоев при первом же нажатии, не печатайте деталь плашмя (на донышке).
Ориентация: Положите модель на бок (поверните на 90°). При такой укладке слои будут идти вдоль штифтов, что в разы увеличит их прочность на излом.
Поддержки: Да (лучше всего использовать древовидные/organic поддержки).
Материал: ABS, ASA или PETG. Обычный PLA не подойдет — он слишком хрупкий для подобных защелок.
Заполнение (Infill): 40–100% (сетка или гироид).
Количество стен (Perimeters): Минимум 4 периметра для монолитности силовых элементов.
