1 / 7
92075-019 Kawasaki Fuel Tank Damper Rubber Grommet H1 Rear Fender ETC — image 1
1 / 7

92075-019 Kawasaki Fuel Tank Damper Rubber Grommet H1 Rear Fender ETC

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Its a rubber grommet for an old Kawasaki or rather a million models

Rating
0 / 5
Likes
2
Downloads
6
Makes
0
Views
42
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Public Domain

About

Have you seen the prices of these stupid things. I am not willing to pay that. 

This is pretty close but probably a little off as I did not have the actual rubber bit to work from. I was able to work backwards and design one pretty close. 

Youll make this in TPU and the spacer is provided to be printed PLA. It does not bond to TPU and so adding a pause in the print will allow you to insert the spacer and have a clean gap without awful supports. Then just wiggle them and they fall out. 

Once you slice the print, look at the sliced model, find the layer where before the top is started and add a pause by right clicking on the right-hand side bar assuming youre using orca based slicer like bambu/elegoo/anycubic/etc.

Tags