Garage Door Arm Bushing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bushing to reduce slack and play where the arm.meets the door.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 4
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Public Domain
I made this bushing for my garage door for where the opener arm.attaches to the door and rattles. The bracket on the door is often wide (20mm or so) while the arm is only 7mm or so think. This reduces tattle and banging and keeps the arm from moving around in the bracket. The bushing could have been a punch of washers on either side, but this is much easier to install in less than a minute but pulling the pin, inserting the bushing with the arm in the middle, and replacing the pin after.
If you prefer thick washers to the one piece bushing, I have included a simple model for 3.5mm thick washers with an 8mm hole.
I printed in PETG with 15% gyroid infill in under 20 minutes on a Bambu P2S.