Slim Snap-Fit case for Waveshare ESP32-S3 RLCD 4.2 board
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple snap-fit case for the Waveshare ESP32-S3 RLCD board, leaving cutouts for the GPIOs, SD card and speaker
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 132
- Makes
- 0
- Views
- 478
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Simple snap-fit case for the Waveshare ESP32-S3 RLCD board. Gives a little better protection to the fragile reflective LCD. Leaves cutouts for the GPIOs, SD card and speaker. Leaves all three buttons accessible. Includes ports for the microphones and temperature sensor. Leaves the battery exposed so it's easier to remove.
Print instructions:
Print from PLA or PETG using 0.13-0.15 layer height
case_front 1x, case_back 1x, button 3x
Print without supports
You might need to clean the overhangs around the buttons if your bridging isn't dialed in
Assembly:
Hold the front panel vertically upside-down and place the buttons in the case, make sure the buttons move freely (reprint the buttons at 95% scale in x and y if they're stuck)
Insert the dev-board
Snap on the back panel, you can screw in the board using the original screws but the board locates nicely in the indented holes so it's not necessary
Insert the legs, you can reuse the acrylic legs that the board came with or if they're already snapped, print new ones, the files for it are included