1 / 1
Fast Desiccant Holder — image 1

Fast Desiccant Holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Sturdy Desiccant Holder, with louvres for great venting and fast printing in Vase mode.

Rating
0 / 5
Likes
6
Downloads
61
Makes
0
Views
184
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Open Community License v1.1 + Micro Business v1

This sleek & sturdy desiccant holder prints fast and uses only 8 grams of material. It is optimized for spiral vase mode, with wide louvres for great venting.

  • Cap with a quarter turn bayonet closure and a secure snap

  • 50 x 50 mm. size; easily drops into and out of the center of a spool

  • Holds 65 grams of desiccant

  • < 1.6 mm. vent openings, should work for regular desiccant pellets (> 2 mm. size)

  • 43 minutes to print on a Prusa Mk4

Print Instructions

  • Print in Spiral Vase Mode only

  • tested with PLA, should work with other materials

  • Nozzle:

    • 0.4 mm. with 0.7 mm extrusion width (critical for a good fit of the cap)

    • Or 0.6 mm with default extrusion width of 0.68 mm (in Prusaslicer)

  • 0.2 mm. to 0.25 mm. layer height 

  • 0.6 to 0.9 mm. bottom shell thickness (default setting)

  • No supports or brim needed

  • Print both parts individually in Vase Mode; orient them with the slotted face down on the build plate

Assembly & Use

  • To tighten the cap, twist clockwise until it clicks.  

  • To open the cap, twist counterclockwise.

  • A light squeeze on the 3 dots makes it easier to open or close if it is a bit stiff.

  • You can fill it to the brim with desiccant pellets.

Acknowledgements

This is an original design, with inspiration from a few other designs: 

Revision History

Version 1.0 - July 19, 2026: Initial publication

Version 1.1 - November 2, 2026:

  • Optimized lid interface to a clockwise quarter turn.

  • Added a secure lock snap.

Tags