1 / 8
Case for Heltek V3 with 18650 or 21700 battery — image 1
1 / 8

Case for Heltek V3 with 18650 or 21700 battery

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Case for Heltek V3Fits Heltec V3 with soldered pins

Rating
5 / 5
Likes
6
Downloads
38
Makes
0
Views
229
Reviews
2

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial — Share Alike

Case for Heltek V3

  • Fits Heltec V3 with soldered pins!

  • Requires: 4x M2x10mm screws and 4x M2 brass heat-set inserts.

  • Battery: Designed for a 21700 battery. For an 18650 battery, you must add a soft spacer (gasket).

  • BMS Required: You must use a battery protection board (BMS). Heltec does not have deep discharge protection and will drain the battery below 2V, damaging it.

  • Buttons: Use transparent plastic for the buttons so the LED light can shine through.

  • Charging: The built-in Heltec charge current is only 150–200mA. The battery will charge very slowly.

  • Power Consumption:

    • ESP32-S3: ~120mA (idle) or ~30–50mA with optimized firmware.

    • SX1262 (LoRa): ~5mA (idle/RX) and up to 140mA @ 22dBm during packet transmission (lasts less than a second).

  • Future Upgrade: A future case version may include an external charging board with a BMS (like a TP4056 module). There is already some free space inside for this.

  • FreeCAD sources available! Edit it for your needs!

Tags