1 / 5
Stand/ Holder for China chamber heater in Snapmaker U1 — image 1
1 / 5

Stand/ Holder for China chamber heater in Snapmaker U1

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Für eine preiswerte Bauraumheizung im SMU1 - For a cheap chamber heater inside SMU1

Rating
0 / 5
Likes
1
Downloads
2
Makes
0
Views
145
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

-> Version V2 mit Freigang für das hintere Lüftungsgitter.

Ich kaufte eine preiswerte Heizung für den Bauraum von meinem eingehausten Sovol SV04.

Nun besitze ich neuerdings den Snapmaker U1, welche nach der Einhausung ebenfalls eine Heizung benötigt. Daher verwende ich erst einmal die vorhandene Heizung, da sie sehr gut im hinteren Bereich des SMU1 passt. Zudem kann man sie mit der passenden Fernbedienung steuern.

Der Ständer ist aus PETG (Gedruckt mit 0,6er Düse, drei Perimeter und 25% Triangle-Infill) und wird mit den Schrauben von einer Sicherheitsbrücke des SMU1 befestigt.

Die unteren Aussparungen dienen der Positionierung und dem ebenmäßigen Stand des Ständers. Die Ansaugung der Luft ist am hintern Teil der Heizung. Darum habe ich Platz zur Rückwand gelassen.

Das Stromkabel wird natürlich nach hinten herausgeführt :-). Dazu werde ich eine neue Rückwand fertigen, da ich in die aktuelle wegen der Garantie erst mal kein Loch bohren möchte.

Die Heizung ist leider nicht mehr zu erwerben. Aber vielleicht hat jemand die gleiche Heizung gekauft.

Das 3D-Modell kann natürlich gerne als Vorlage für eigene Kreationen dienen.

-> Version V2 with an opening for the rear ventilation fence.

I bought an inexpensive heater for the build chamber of my enclosed Sovol SV04.

I’ve recently acquired the Snapmaker U1, which also needs a heater once it’s enclosed.

So for now, I’m using the existing heater, since it fits very well in the rear section of the SMU1. In addition, you can control them with the appropriate remote control.

The stand is made of PETG (printed with a 0.6 nozzle, three perimeters, and 25% triangle infill) and is secured with screws from a safety bridge on the SMU1.

The lower cutouts help position the stand and keep it level. The air intake is at the back of the heater. That's why I left some space between it and the back wall.

The power cable is, of course, routed out the back :-). I’ll be making a new back panel for this, since I don’t want to drill a hole in the current one just yet due to the warranty.

Unfortunately, the heater is no longer available for purchase. But maybe someone else has bought the same heater.

Feel free to use the 3D model as a template for your own creations.

Tags