Thumbstick Box for BSP Gamepads

A compact storage box for the thumbstick caps of BSP gamepads. Comes with a cap puller too.

If you were foolish enough (like me) to have bought the BSP-D8+ gamepad, you might've noticed that the extra thumbstick caps come in a plastic bag. Why not store them in something more respectable and stylish?

Features:

• Storage for four different pairs of thumbstick caps

• Cap puller with two different anchors - choose between parallel or perpendicular orientation when pulling

• Spring-loaded latch

• Print-in-place hinge mechanism

Print notes:

• Tested with PLA

• Make sure to enable whatever setting that allows the printing of thin walls in your slicer, or else the spring won't print

• Supports needed? - No

• You might notice the box might not close fully due to tight tolerances in the hinge

  • This is normal, just close it and place something heavy on it for a few hours to let it "break-in"

  • I've adjusted and tested this model countless times, and the only way to have it close fully without “break-in" is to either make the hinge mechanism bigger, or make the tolerances so large that the entire box becomes rattly and loose

  • If you have experience with modelling and printing tiny print-in-place hinges, feel free to share your tips!

By the way, if you haven't yet, don't buy the BSP-D8+. It's a disappointment.