1 / 1
Magnetic Phone Mount for Tesla Model 3 (2017-2026) - Air Vent Clip — image 1

Magnetic Phone Mount for Tesla Model 3 (2017-2026) - Air Vent Clip

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Magnetic Phone Mount that clips into the air vent of a Tesla Model 3 (2017-2026).

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
47
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

Magnetic Phone Mount that clips into the air vent of a Tesla Model 3 (2017-2026).

A magnetic pad for your phone. Takes a single N52 disc 20x3 mm, glued into the recess on the back - so the magnet sits close to the phone and the grip is strong.

You need: one neodymium disc 20x3 mm N52 and a steel plate on the phone (or a MagSafe-compatible case).

FITMENT

Tesla vents are a CONTINUOUS SLOT with no blades at all - every 'blade clip' on the market is useless here. This one is a friction wedge with ribs that expands inside the slot.

The jaw is deliberately sprung rather than a fixed slot, because real vent blades vary between cars and even between the left and right vent of the same dashboard. If it ends up tight, it is meant to be - it holds by friction and should need a firm push.

MATERIAL - THIS ONE MATTERS

Print in PETG or ASA. Not PLA. A parked car in the sun goes past 60-70 C inside, and PLA starts to soften around 55 - a PLA clip will sag off the vent, taking whatever it was holding with it. This is not a preference, it is the condition for the part working at all.

Settings: 0.2 mm layers, 4 perimeters, 30% infill, no supports. Print as oriented - the whole part is one extruded profile lying on a flat face, and the spring jaw bends in the plane of the layers, which is the only orientation that survives repeated clipping.

Not affiliated with, endorsed by, or connected to any vehicle manufacturer. Brand and model names describe fitment only.

Tags