Lenovo Thinkcentre Tiny VESA 200×200 Corner Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple and lightweight corner mounting brackets for attaching a Lenovo Tiny PC to the back of a TV or monitor.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
Simple and lightweight corner mounting brackets for attaching a Lenovo Tiny PC to the back of a TV or monitor using a VESA 200×200 mm mounting pattern.
The design uses less material than many similar mounts while leaving the PC largely uncovered. This allows for a small footprint, so you can print it on even the smalles printers such as the A1 mini. It also keeps the buttons and cable ports easily accessible and allows good airflow around the device.
The brackets are strong enough to support the PC securely. With PETG, my complete TV can even be lifted using the mount — probably more strength than you will ever need.
Compatibility
The brackets are designed for Lenovo Tiny PCs with dimensions of approximately:
180 × 185 × 35 mm
I designed and tested the mount with a Lenovo ThinkCentre Tiny M920q. It may also fit other Lenovo Tiny models with the same or very similar dimensions, including:
M720q, M920q, M920x, P330, M75q, M75q Gen 2, M70q, M80q, M90q, P340, M70q Gen 2, M90q Gen 2, P350, M80q Gen 3, M90q Gen 3, P360, and potentially other models.
Please check the dimensions of your specific PC before printing.
Mounting Hardware
The VESA mounting holes support screws up to M8. Smaller screws can also be used with suitable washers. The brackets are designed to accommodate washers up to 20 mm in diameter. Make sure that the screws used are appropriate for your TV or monitor and do not extend too far into the VESA mounting holes of your device.
Printing
I printed the brackets in PETG for increased strength and durability. PLA should also work. Supports are required due to the overhangs in the design. Recommended starting settings:
Material: PETG or PLA
Supports: Yes
Infill: 50%
Perimeters/walls: 4