1 / 3
Minimalist Elevated Pet Bowl Stand (Cat / Dog Feeder) – Scalable — image 1
1 / 3

Minimalist Elevated Pet Bowl Stand (Cat / Dog Feeder) – Scalable

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A sleek, modern, and sturdy elevated bowl riser designed for cats, puppies, and small dogs.

Rating
0 / 5
Likes
32
Downloads
41
Makes
0
Views
252
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial — Share Alike

Ergonomic Elevated Dual Pet Bowl Stand

A sleek, modern, and sturdy elevated bowl riser designed for cats, puppies, and small dogs. Raising the feeding station promotes a more natural neck posture during eating and drinking, helping to improve digestion and reduce neck strain.

The design incorporates a lightweight honeycomb grid between the bowl cutouts, saving filament while adding a clean, modern aesthetic.

Key Features

  • Ergonomic Eating Angle: Elevates water and food to reduce stress on your pet's neck, joints, and spine.

  • Modern Honeycomb Lattice: Center hexagonal pattern saves print time and material without sacrificing structural strength.

  • Arch Cutouts: Side and front arched cutouts make picking up, moving, and cleaning underneath effortless.

  • 100% Scalable: Need a larger or smaller bowl size? Uniformly scale the model in your slicer (X/Y/Z) to match your custom stainless steel or ceramic pet bowls.

  • Default Inner Ring Diameter: Designed to fit standard ~115–120 mm (outer lip ~130–135 mm) pet bowls at 100% scale.

💡 Sizing & Scaling Guide

If your bowls have a different rim diameter:

  1. Measure the outer diameter of your bowl below the rim (the diameter of the hole needed).

  2. Divide your measured bowl diameter by the model's hole diameter (~118 mm) and multiply by 100 to get your scale percentage in Bambu Studio / OrcaSlicer.

    • Example: If your bowl needs a 140 mm hole: (140 / 118) * 100 = ~118.6% scale.

Print Settings

Parameter

Recommended Setting

Material:

PETG (preferred for water resistance, easy washing, and durability) or PLA

Layer Height:

0.20 mm (Standard)

Walls / Perimeters:

3 to 4 (recommended for rigid side legs)

Infill Density:

15%

Infill Pattern:

Gyroid

Supports:

None (print upside down / top face flat on the build plate as sliced)

Brim:

use 5mm outer brim

Tags