1 / 4
"Pokey spoke" handle - printable handle for bicycle wheel spoke — image 1
1 / 4

"Pokey spoke" handle - printable handle for bicycle wheel spoke

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Convenient handle for a pokey spoke, a bike shop service standard tool - a spoke usually sharpened to a point.

Rating
0 / 5
Likes
3
Downloads
7
Makes
0
Views
73
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Nice handle for a "pokey spoke" which is a bike shop service area classic, just a spare spoke that's been sharpened to a point. Most often the spoke is bent to create a handle, this gives you a nice printed handle that makes it look a little better than the classic bent spoke.

Prints with no supports, upright on the print bed. You may wish to enable a brim depending on your printer's bed adhesion, but I usually don't need it. Doesn't need to be tremendously thick, I'll usually do only three shells.

Once printed, take a spare spoke and make a mark 25mm down from the threaded end. This will give you an idea of how far you've got to go while threading it on, as that's how deep the hole is. My suggestion is to mount the spoke threads up in a bench vise, then drop the handle on and start turning. It is going to be slow going as a standard spoke thread is 56tpi, which means you'll only get 0.4mm with each full turn of the handle - and since you'll only be able to turn it a half turn at a time, it'll take about 50 turns to fully seat the spoke. The upside is it'll then be really securely installed.

I most commonly use straight 2mm spokes (which are very generic and widely available) and reach for that the most often. A 1.5mm spoke, such as the double butted DT Revolution or Sapim Laser, still has the 2.0mm threaded end that works with this handle, but the spoke is quite a bit flexier. I like to leave those long and find they can be handy for tasks like dealing with internal cable routing.

In the photo on the pegboard you can also see I have a 2.6mm spoke, which is uncommon, but makes for a really nice, robust pick. If you have access to those, let me know and I can post a variation of the handle that'll work with that.

If that's all too flimsy for your tastes, check out "The Trevor" which uses an upcycled old quick release skewer to make a positively fearsome pick, or an excellent grip removal tool: 

Tags