1 / 3
Rlaarlo Omni Terminator Rear Body Guard — image 1
1 / 3

Rlaarlo Omni Terminator Rear Body Guard

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Printable replacement rear body guard for the Rlaarlo Omni Terminator with M2.5 mounting holes and a wraparound design.

Rating
0 / 5
Likes
3
Downloads
17
Makes
0
Views
74
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A printable replacement-style rear body guard for the Rlaarlo Omni Terminator, featuring a ribbed top, raised ends, and a rounded wraparound backside.

I designed this to replace my missing rear guard using measurements from my truck and reference photos of the original part. The final model was printed and successfully fitted to my setup.

Hardware and installation

You’ll need two M2.5 screws of a suitable length for your body/support thickness.

  1. Position the guard and check that both mounting bosses seat properly.

  2. Make sure the guard rests comfortably over the body without forcing it.

  3. Install the screws from underneath into the pilot holes.

  4. Tighten gently by hand until snug.

  5. Check clearance around the rear body and bumper before driving.

Printing notes

Print at 100% scale. Scaling the entire model will change the screw spacing.

Suggested starting settings—not a tested full-part print profile:

  • Layer height: 0.20 mm

  • Perimeters: 3-4

  • Infill: 40%

  • Material: TPU 95A, ASA, PETG

  • Use a filament profile you already have dialed in.

  • Inspect overhangs in the slicer and add supports where needed for your chosen orientation.

  • Keep support material out of the screw holes where possible.

If you print one, please share a Make with your filament, settings, and an installed photo. Feedback on fit is welcome!

Included download

omni_rear_guard.stl

omni_rear-guard.3mf

Tags