1x1 LU Multibin Insert - 608 Bearing Soldering Iron Stand (TS100 / TS101 / Pinecil)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
1x1 LU Multibin insert using a standard 608 bearing as a heat shield for TS100, TS101, and Pinecil irons.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 4
- Makes
- 0
- Views
- 67
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
A 1x1 LU Multibin Insert designed as a soldering iron stand insert for MultiBuild bins. It uses a 608 bearing press-fitted into the center as a thermal barrier, preventing the hot tip of portable soldering irons from contacting or melting the 3D printed housing.
Compatibility
Supported Irons: TS100, TS101, Pinecil, Pinecil V2, FNIRSI HS-01, and other portable soldering irons utilizing similar tip diameters.
Modular Use: Designed to pair seamlessly with 2x2 LU Multibin Insert - Brass Wool Tip Cleaner Holder and other Multibin inserts inside a divided Micro Shell.
Assembly & Installation
Place the insert into a Micro Shell. (For example: 2x1 micro shell)
Secure it using Multibin Insert Pins in the corner mounting points to add structural stability to the stand.
Press a 608 bearing into the recess, there are some crush fins on the sides which are intended to deform out of the way when pressed with enough force. If using a rubber sealed bearing, remove the rubber seal before inserting.
Print Settings
Print using standard MultiBuild guidelines:
Layer Height: 0.2 mm
Wall Perimeters: 3
Infill: 15%
Supports: None
Parts list for setup in photo
To recreate the full setup shown in the preview photo, you will need:
1x 1 LU Divider & 1x 2 LU Divider
3x Outer Wall Pins & 1x Inner Wall Pin
10x Fix Point Hole Magnet Holders + 10x 10x2mm Magnets
1x 608 bearing
