1 / 2
1x1 LU Multibin Insert - 608 Bearing Soldering Iron Stand (TS100 / TS101 / Pinecil) — zdjęcie 1
1 / 2

1x1 LU Multibin Insert - 608 Bearing Soldering Iron Stand (TS100 / TS101 / Pinecil)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

1x1 LU Multibin insert using a standard 608 bearing as a heat shield for TS100, TS101, and Pinecil irons.

Ocena
0 / 5
Polubienia
6
Pobrania
4
Wydruki
0
Wyświetlenia
67
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

A 1x1 LU Multibin Insert designed as a soldering iron stand insert for MultiBuild bins. It uses a 608 bearing press-fitted into the center as a thermal barrier, preventing the hot tip of portable soldering irons from contacting or melting the 3D printed housing.

Compatibility

  • Supported Irons: TS100, TS101, Pinecil, Pinecil V2, FNIRSI HS-01, and other portable soldering irons utilizing similar tip diameters.

  • Modular Use: Designed to pair seamlessly with 2x2 LU Multibin Insert - Brass Wool Tip Cleaner Holder and other Multibin inserts inside a divided Micro Shell.

Assembly & Installation

  1. Place the insert into a Micro Shell. (For example: 2x1 micro shell)

  2. Secure it using Multibin Insert Pins in the corner mounting points to add structural stability to the stand.

  3. Press a 608 bearing into the recess, there are some crush fins on the sides which are intended to deform out of the way when pressed with enough force. If using a rubber sealed bearing, remove the rubber seal before inserting.

Print Settings

Print using standard MultiBuild guidelines:

  • Layer Height: 0.2 mm

  • Wall Perimeters: 3

  • Infill: 15%

  • Supports: None

Parts list for setup in photo

To recreate the full setup shown in the preview photo, you will need:

Tagi