MASS NAS GPU module (Modcase)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Module for the Modcase MASS NAS case (free version) to mount a dual slot gpu
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a module for the great MASS NAS case (free version) that allows you to mount a dual slot GPU. To connect the GPU to your mainboard you need a PCIE riser cable (the mounting points probably need adjustments for that) or a PCIE extension board (i'm using this board, mounting points are designed for this).
It is designed to be attached above the mainboard cage and has small supports to allow a fan module (140mm) to be attached on top.
It only fits short GPUs, my Gainward Pegasus NVIDIA GeForce RTX 3050 with a length of ~170mm fits just right. If your GPU needs more power than what your PCIE port can deliver you probably need a 180 degree power connector.
It is a very tight fit and fastening some of the screws can be a hassle, so plan ahead with cable management. Assembly order should be like this:
install heat set inserts
attach GPU to your PCIE board/riser cable
insert GPU/PCIE combo
(optional) insert bracket spacer
lightly fasten bracket screw
fasten PCIE board/riser cable screws
tighten bracket screw
screw in the screws that connect to the module above until the tip of the screw peaks out of the GPU module
attach all cables to the GPU
install the module above and tighten the screws from step 8
place the GPU module above the mainboard cage
route the cables from the top modules to the mainboard
screw in the screws that connect the mainboard cage to the GPU module
Besides the module there are two more optional models, that you can scale in Z (keep x and y as is) depending on your exact measurements:
top spacer: goes between the GPU and fan module, if you need additional space there (e.g. when using a 180 degree power connector).
bracket spacer: close the gap between the bracket and the mounting point for the bracket to keep the GPU straight
You need this hardware:
5x heat set insert M3x5x4
5x M3 4-6 mm SHCS/BHCS screws (length depends on the thickness of your bracket and PCIE board/riser cable)
4x M3x20 screws (the ones that are used for all the other parts of the case)
PCIE extension board/riser cable
Print settings:
Printed with the same settings as the rest of the case, but enable supports.