1 / 4
Mount for Ecowitt Sensor Radiation Shield — image 1
1 / 4

Mount for Ecowitt Sensor Radiation Shield

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For mounting the original sensor radiation shield on an exterior windowsill. Easily clip the sensor on and off.

Rating
0 / 5
Likes
2
Downloads
3
Makes
0
Views
32
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Sensormount for ecowitt Sensor Radiation Shield

Intended use

The original shield for the ecowitt WH57/WN32/WN31/WN30 is delivered with a mounting-arm that is of little use for mounting the sensor on a flat surface, e.g., on a windowsill. Furthermore the procedure to clip it on/off to the original baseplate is not very refined.

Thus this new baseplate replaces the original arm and baseplate with a design with these features:

  • Mounts to a flat surface either with two countersunk screws or doublesided tape

  • Allows angular compensation for upright positioning of the shield

  • Smooth and reliable locking mechanism via two buttons

The original shield itself is used as it is.

Remark: The uploaded files contain also a model of the bottom of the shield, but this was only used as a template/shapebinder for designing the new baseplate

Partslist

To buy

Part

Pieces

Ecowitt Sensor Radiation Shield / original part

1

Screw M3x30 ISO7380-1 (or similiar type)

2

Screw M3x35 ISO7380-1 (or similiar type)

1

Nut M3 DIN934

1

Spring 7x19mm (or similiar size)

2

Spring 5,5x38mm (or similiar size)

2

To print

Part

Pieces

EcoWitt_Top

1

EcoWitt_Bottom (choose one from two versions) 

1

Plunger

2

Spring_Lock

2

LockTab

2

Angle_Lockplate_Screwed

1

Lockplate_Nut_Screwed

1

Make

Printing hints

Original make used a Prusa Mk4S, PETG (Filatech Easy PETG, Extrudr PETG) and Prusa Slicer. Only a few parameters of the standard slicer-setup "0,2mm Structural" have been changed - please see the 3mf-files.

Remark: Due to my experience, the Prusament PETG-profile works better for the Extrudr PETG (not XPETG) than the dedicated Extrudr PETG-profile of the slicer - I use the Prusament-profile for Extrudr-PETG. For Filatech, the profile in the slicer works fine or me.

Assembly
  • insert the plungers, and short springs into the Top and lock them by turning the springlocks 90 degree with a slotted screwdriver

  • Insert the buttons "LockTab" with the long springs and secure them with the 30mm-screws

  • Press the M3-Nut into Lockplate_Nut_Screwed

  • Press the Lockplate_Nut_Screwed through the hex-hole in Angle_Lockplate_Screwed

  • Insert the lockplate-assembly through the bottom-hole into EcoWitt_Top and secure it with the 35mm-screw

Remark: The difference between the two versions of the EcoWitt_Bottom is just that one has no screwholes and is intended only for mounting with double sided tape. The more versatile variant is the one with the screwholes.

Finally

I would be glad if you find the design useful - have fun!

Tags